Frequently asked questions about our new CALPlex datalogger.

Video on how to install wires through a retort packing gland.

Video on how to install a thermocouple in a plastic cup.

Video on how to install a thermocouple in a flexible pouch.

Video on how to install a thermocouple in a glass jar lid.

Video on how to install a thermocouple in a can.

When testing with a wired data collection system in a water retort, there can sometimes be an issue where the pressure inside the retort forces water through the lead wire insulation, and can even reach the CALPlex (which may affect performance). To eliminate this, we recommend that you cut away the exterior insulation and "split" or separate the red and blue wires from each other. This allows the water to drip out and exit before it reaches the CALPlex.

When you receive your subminiature connector, it will come already assembled, and you will have to partially disassemble it to install it. This video and article will walk you through how to disassemble your connector, install it onto a lead wire, and reassemble it.

When you receive your thermocouple connector, it will come unassembled in a bag. This video and article will walk you through how to assemble your connector and install it onto a lead wire.

M12 Rigid Probes are sized to fit the ThermaLock Fittings they will be installed into. Therefore, both the length of the probe and the length of the fitting depend on the size of the container to be tested.